TDT - Productivity solutions for technical illustrators.

Step 13
Go to page 28, Symbol #060

Duplicate the “L” extrusion that you place outside the page area and move it within the guidelines. Dupe it again and apply a horizontal mirror. Use the Node Edit Tool to drag in the lower outside nodes.

Weld together and delete any extra nodes. Make sure all of the segments are straight lines.

Step 14
Go to page 29, Symbol #061

Duplicate the “L” angle and move it within the guidelines. Dupe it again and apply a horizontal mirror. Use the Node Edit Tool to drag in the lower outside nodes.

Weld together and delete any extra nodes. Make sure all of the straight segments are straight lines.

Step 15
Go to page 28, Symbol #060

Copy the “U” extrusion and go to page 30, Symbol #062 and paste. Paste again and apply a vertical mirror and move the ends up and down a bit. Weld together and then create a 5.00-inch rectangle.

Center the rectangle on the box and trim it from the box. Delete the rectangle and any extra nodes. Make sure all of the segments are straight lines.